OS-C501

Recommendations

Info

Offshore Standard DNV-OS-C501, November 2013 Sec.14 Calculation example: two pressure vessels – Page 206 Table 14-31 Elastic properties Property after 25 years in water after 25 years in water with matrix cracking E 1 fibre 21.3 GPa 21.3 GPa E 2 matrix 6.8 GPa 0.08 GPa ν 12 0.29 0.003 G 12 linear 2.9 GPa 0.03 GPa 7.6.5 The laminate modulus in the 15 degree direction is obtained by calculation the Young's modulus in the main x-direction for the original laminate rotated by - 15 degrees, i.e.: Table 14-32 Rotated laminate (-15°) Ply no: Fibre angle (°) 1 0 2 - 30 3 70 4 - 100 5 70 6 - 100 7 - 100 8 70 9 - 100 10 70 11 - 30 12 0 The laminate modulus is obtained from laminate theory calculations. Even though the laminate is not symmetric and the laminate modulus is not a meaningful value, it is sufficient for the calculation γ a . The results are: 10.31 GPa for non-degraded properties, and: 4.04 GPa for the laminate with matrix cracks. Therefore: γ A = E lin /E nonlin , = 2.55 for the 15 degree ply. 7.6.6 The laminate modulus in the - 15 degree direction is obtained in a similar way by rotating the original laminate by +15 degrees. The result is the same as in [7.6.5]. 7.6.7 The laminate modulus in the 85 degree direction is obtained by calculation the Young's modulus in the main x-direction for the original laminate rotated by - 85 degrees, i.e.: Table 14-33 Rotated laminate (-85°) Ply no: Fibre angle (°) 1 - 70 2 - 100 3 0 4 - 170 5 0 6 - 170 7 - 170 8 0 9 - 170 10 0 11 - 100 12 - 70 The laminate modulus is obtained from laminate theory calculations. Even though the laminate is not symmetric and the laminate modulus is not a meaningful value, it is sufficient for the calculation γ a . The results are: 16.02 GPa for un-degraded properties, and: 12.01 GPa for the laminate with matrix cracks. Therefore: γ A = E lin /E nonlin , = 1.33 for the 85 degree ply. 7.6.8 The laminate modulus in the - 85 degree direction is obtained in a similar way by rotating the original laminate by + 85 degrees. The result is the same as in [7.6.7]. 7.6.9 Analysing the design criterion above (see [7.6.2]) we find the maximum allowable strain in fibre direction ε nk after 25 years of service to be: DET NORSKE VERITAS AS
Offshore Standard DNV-OS-C501, November 2013 Sec.14 Calculation example: two pressure vessels – Page 207 maximum strain in 15 o plies: maximum strain in 85 o plies: The maximum ply strains in fibre direction calculated by this method are 0.17%. This shows that fibres are not predicted to fail. Guidance note: Note that these strains are artificially low to compensate for the simplified calculation method used. ---e-n-d---of---G-u-i-d-a-n-c-e---n-o-t-e--- 7.7 Fibre dominated ply failure due to static long-term loads (ref. Sec.6 [10]) 7.7.1 The analysis method is the same as for the water vessel in [6.8]. 7.8 Fibre dominated ply failure due to cyclic fatigue loads (ref. Sec.6 [11]) 7.8.1 The analysis method is the same as for the water vessel in [6.9]. 7.9 Unacceptably large displacement 7.9.1 Same as in [6.10], no requirements to be checked. 7.10 Impact resistance 7.10.1 Same as in [6.11]. 7.11 Explosive decompression 7.11.1 Same as in [6.12]. 7.12 Chemical decomposition 7.12.1 Same as in [6.13]. 7.13 Summary evaluation 7.13.1 Summarising as follows: ε nk ε = γ γ Sd ε ε nk = γ γ Sd ∧ fiber k FM FM . γ ∧ fiber k . γ Rd Rd 0.87 = = 0.275% 1.05× 1.18× 2.55 0.87 = = 0.528% 1.05× 1.18× 1.33 — The analysis and results are identical to the non-linear analysis. — This method is more complicated in this example, but may be simpler in larger structures, because the analysis has to be done only once. — The conclusions are also identical to the non-linear analysis in [6.14]. DET NORSKE VERITAS AS
Page 1 and 2:
OFFSHORE STANDARD DNV-OS-C501 Compo
Page 3 and 4:
Offshore Standard DNV-OS-C501, Nove
Page 5 and 6:
Page 7 and 8:
Page 9 and 10:
Page 11 and 12:
Page 13 and 14:
Page 15 and 16:
Page 17 and 18:
Page 19 and 20:
Page 21 and 22:
Page 23 and 24:
Page 25 and 26:
Page 27 and 28:
Page 29 and 30:
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Page 37 and 38:
Page 39 and 40:
Page 41 and 42:
Page 43 and 44:
Page 45 and 46:
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Page 55 and 56:
Page 57 and 58:
Page 59 and 60:
Page 61 and 62:
Page 63 and 64:
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Page 77 and 78:
Page 79 and 80:
Page 81 and 82:
Page 83 and 84:
Page 85 and 86:
Page 87 and 88:
Page 89 and 90:
Page 91 and 92:
Page 93 and 94:
Page 95 and 96:
Page 97 and 98:
Page 99 and 100:
Page 101 and 102:
Page 103 and 104:
Page 105 and 106:
Page 107 and 108:
Page 109 and 110:
Page 111 and 112:
Page 113 and 114:
Page 115 and 116:
Page 117 and 118:
Page 119 and 120:
Page 121 and 122:
Page 123 and 124:
Page 125 and 126:
Page 127 and 128:
Page 129 and 130:
Page 131 and 132:
Page 133 and 134:
Page 135 and 136:
Page 137 and 138:
Page 139 and 140:
Page 141 and 142:
Page 143 and 144:
Page 145 and 146:
Page 147 and 148:
Page 149 and 150:
Page 151 and 152:
Page 153 and 154:
Page 155 and 156: Offshore Standard DNV-OS-C501, Nove
Page 205: Offshore Standard DNV-OS-C501, Nove
show all

OS-C501

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?