OS6860(E)_AOS_8.1.1.R01_Switch_Management_Guide

Recommendations

Info

SNMP Specifications Using SNMP SNMP Specifications The following table lists specifications for the SNMP protocol. Platforms Supported RFCs Supported for SNMPv2 RFCs Supported for SNMPv3 SNMPv1, SNMPv2, SNMPv3 SNMPv1 and SNMPv2 Authentication SNMPv1, SNMPv2 Encryption SNMPv1 and SNMPv2 Security requests accepted by the switch SNMPv3 Authentication SNMPv3 Encryption SNMPv3 Security requests accepted by the switch. SNMP traps OmniSwitch 6860, 6860E 1902 through 1907 - SNMPv2c Management Framework 1908 - Coexistence and transitions relating to SNMPv1 and SNMPv2c 2570 – Version 3 of the Internet Standard Network Management Framework 2571 – Architecture for Describing SNMP Management Frameworks 2572 – Message Processing and Dispatching for SNMP 2573 – SNMPv3 Applications 2574 – User-based Security Model (USM) for version 3 SNMP 2575 – View-based Access Control Model (VACM) for SNMP 2576 – Coexistence between SNMP versions The SNMPv3 protocol is ascending compatible with SNMPv1 and v2 and supports all the SNMPv1 and SNMPv2 PDUs Community Strings None Sets and Gets SHA, MD5 DES, AES Non-authenticated Sets, Non-authenticated Gets and Get-Nexts, Authenticated Sets, Authenticated Gets and Get-Nexts, Encrypted Sets, Encrypted Gets and Get-Nexts Refer to “SNMP Trap Information” on page -1 for a complete list of traps and their definitions. SNMP Defaults The following table describes the default values of the SNMP protocol parameters. Parameter Description Command Default Value/Comments SNMP Management Station snmp station UDP port 162, SNMPv3, Enabled Community Strings snmp community-map Enabled SNMP Security setting snmp security Privacy all (highest) security Trap filtering snmp-trap filter-ip Disabled Trap Absorption snmp-trap absorption Enabled Enables the forwarding of traps to snmp-trap to-webview Enabled WebView. Enables or disables SNMP authentication failure trap forwarding. snmp authentication-trap Disabled page 9-2 OmniSwitch AOS Release 8 Switch Management Guide May 2014
Using SNMP Quick Steps for Setting Up An SNMP Management Station Quick Steps for Setting Up An SNMP Management Station An SNMP Network Management Station (NMS) is a workstation configured to receive SNMP traps from the switch. To set up an SNMP NMS by using the switch’s CLI, proceed as follows: 1 Specify the user account name and the authentication type for that user. For example: -> user NMSuserV3MD5DES md5+des password ******** 2 Specify the UDP destination port number (in this case 8010), the IP address of the management station (199.199.100.200), a user account name (NMSuserV3MD5DES), and the SNMP version number (v3). For example: Note: The user account must already be created as documented in Step 1 above. -> snmp station 199.199.100.200 8010 NMSuserV3MD5DES v3 enable Use the same command as above for specifying the IPv6 address of the management station. For example: -> snmp station 300::1 enable Note. Optional. To verify the SNMP Management Station, enter the show snmp station command. The display is similar to the one shown here: -> show snmp station ipAddress/udpPort status protocol user ---------------------------+---------+--------+------------------------------- 199.199.100.200/8010 enable v3 NMSuserV3MD5DES 199.199.101.201/111 disable v2 NMSuserV3MD5 199.199.102.202/8002 enable v1 NMSuserV3SHADES -> show snmp station ipAddress/udpPort status protocol user ---------------------------------------------------+---------+--------+------ 172.21.160.32/4000 enable v3 abc 172.21.160.12/5000 enable v3 user1 0300:0000:0000:0000:0211:d8ff:fe47:470b/4001 enable v3 user2 0300:0000:0000:0000:0211:d8ff:fe47:470c/5001 enable v2 abc For more information about this display, see the “SNMP Commands” chapter in the OmniSwitch AOS Release 8 CLI Reference Guide. OmniSwitch AOS Release 8 Switch Management Guide May 2014 page 9-3
Page 1 and 2:
Part No. 060391-10, Rev. A May 2014
Page 3 and 4:
Contents About This Guide .........
Page 5 and 6:
Contents Using the Switch as an FTP
Page 7 and 8:
Contents Account and Password Polic
Page 9 and 10:
Contents Authentication Trap ......
Page 11 and 12:
Contents Firmware Upgrade Files ...
Page 13 and 14:
About This Guide This OmniSwitch AO
Page 15 and 16:
About This Guide Documentation Road
Page 17 and 18:
About This Guide Related Documentat
Page 19 and 20:
1 Logging Into the Switch Logging i
Page 21 and 22:
Logging Into the Switch Quick Steps
Page 23 and 24:
Logging Into the Switch Overview of
Page 25 and 26:
Logging Into the Switch Accessing t
Page 27 and 28:
Logging Into the Switch Setting the
Page 29 and 30:
Logging Into the Switch Using Secur
Page 31 and 32:
Page 33 and 34:
Page 35 and 36:
Logging Into the Switch Modifying t
Page 37 and 38:
Logging Into the Switch Enabling th
Page 39 and 40:
Logging Into the Switch Enabling th
Page 41 and 42:
2 Managing System Files This chapte
Page 43 and 44:
Managing System Files Switch Admini
Page 45 and 46:
Managing System Files File and Dire
Page 47 and 48:
Page 49 and 50:
Page 51 and 52:
Page 53 and 54:
Managing System Files Loading Softw
Page 55 and 56:
Managing System Files Loading Softw
Page 57 and 58:
Managing System Files Setting the S
Page 59 and 60:
Managing System Files Setting the S
Page 61 and 62:
3 Managing CMM Directory Content Th
Page 63 and 64:
Managing CMM Directory Content CMM
Page 65 and 66:
Page 67 and 68:
Page 69 and 70:
Managing CMM Directory Content Mana
Page 71 and 72:
Page 73 and 74:
Page 75 and 76:
Managing CMM Directory Content Usin
Page 77 and 78:
4 Using the CLI Alcatel-Lucent’s
Page 79 and 80:
Using the CLI Command Entry Rules a
Page 81 and 82:
Using the CLI Command Help -> sh vl
Page 83 and 84:
Using the CLI Logging CLI Commands
Page 85 and 86:
Using the CLI Customizing the Scree
Page 87 and 88: 5 Working With Configuration Files
Page 89 and 90: Working With Configuration Files Tu
Page 91 and 92: Working With Configuration Files Qu
Page 93 and 94: Working With Configuration Files Co
Page 95 and 96: Working With Configuration Files Cr
Page 97 and 98: Working With Configuration Files Cr
Page 99 and 100: 6 Managing Switch User Accounts Swi
Page 101 and 102: Managing Switch User Accounts User
Page 103 and 104: Managing Switch User Accounts Overv
Page 105 and 106: Managing Switch User Accounts Overv
Page 107 and 108: Managing Switch User Accounts Creat
Page 109 and 110: Managing Switch User Accounts Confi
Page 115 and 116: Managing Switch User Accounts Setti
Page 117 and 118: Managing Switch User Accounts Multi
Page 119 and 120: 7 Managing Switch Security Switch s
Page 121 and 122: Managing Switch Security Switch Sec
Page 123 and 124: Managing Switch Security Authentica
Page 125 and 126: Managing Switch Security Quick Step
Page 127 and 128: Managing Switch Security Setting Up
Page 129 and 130: Managing Switch Security Configurin
Page 131 and 132: 8 Using WebView The switch can be m
Page 133 and 134: Using WebView WebView CLI Commands
Page 135 and 136: Using WebView WebView Overview Conf
Page 137: 9 Using SNMP The Simple Network Man
Page 141 and 142: Using SNMP Quick Steps for Setting
Page 143 and 144: Using SNMP SNMP Overview Using SNMP
Page 145 and 146: Using SNMP Using SNMP For Switch Se
Page 147 and 148: Using SNMP Using SNMP For Switch Se
Page 149 and 150: Using SNMP Working with SNMP Traps
Page 151 and 152: Using SNMP Verifying the SNMP Confi
Page 153 and 154: 10 Web Services, CLI Scripting, and
Page 155 and 156: Web Services, CLI Scripting, and Op
Page 181 and 182: 11 Configuring Network Time Protoco
Page 183 and 184: Configuring Network Time Protocol (
Page 189 and 190:
Configuring Network Time Protocol (
Page 191 and 192:
Page 193 and 194:
Page 195 and 196:
12 Managing Automatic Remote Config
Page 197 and 198:
Managing Automatic Remote Configura
Page 199 and 200:
Page 201 and 202:
Page 203 and 204:
Page 205 and 206:
Page 207 and 208:
Page 209 and 210:
Page 211 and 212:
Page 213 and 214:
Page 215 and 216:
Page 217 and 218:
Page 219 and 220:
13 Configuring Virtual Chassis A Vi
Page 221 and 222:
Configuring Virtual Chassis Virtual
Page 223 and 224:
Configuring Virtual Chassis Quick S
Page 225 and 226:
Page 227 and 228:
Configuring Virtual Chassis Managin
Page 229 and 230:
Configuring Virtual Chassis Managin
Page 231 and 232:
Page 233 and 234:
Page 235 and 236:
Configuring Virtual Chassis Interac
Page 237 and 238:
Configuring Virtual Chassis Configu
Page 239 and 240:
Configuring Virtual Chassis Configu
Page 241 and 242:
Configuring Virtual Chassis Display
Page 243 and 244:
A Software License and Copyright St
Page 245 and 246:
Alcatel-Lucent License Agreement Al
Page 247 and 248:
B SNMP Trap Information This append
Page 249 and 250:
SNMP Traps Table No. Trap Name Obje
Page 251 and 252:
Page 253 and 254:
Page 255 and 256:
Page 257 and 258:
Page 259 and 260:
Page 261 and 262:
Page 263 and 264:
Page 265 and 266:
Page 267 and 268:
Page 269 and 270:
Page 271 and 272:
Page 273 and 274:
Page 275 and 276:
Page 277 and 278:
Page 279 and 280:
Page 281 and 282:
Page 283 and 284:
Page 285 and 286:
Page 287 and 288:
Page 289 and 290:
Page 291 and 292:
Page 293 and 294:
Index Symbols !! command 4-6 A aaa
Page 295 and 296:
Index Network Time Protocol see NTP
show all

OS6860(E)_AOS_8.1.1.R01_Switch_Management_Guide

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?