OS6860(E)_AOS_8.1.1.R01_Switch_Management_Guide

Using SNMP
Verifying the SNMP Configuration
Verifying the SNMP Configuration
To display information about SNMP management stations, trap management, community strings, and
security, use the show commands listed in the following table.
show snmp station
show snmp community-map
show snmp security
show snmp statistics
show snmp mib-family
show snmp-trap replay-ip
show snmp-trap filter-ip
show snmp authenticationtrap
show snmp-trap config
Displays current SNMP station information including IP address, UDP
Port number, Enabled/Disabled status, SNMP version, and user account
names.
Shows the local community strings database including status, community
string text, and user account name.
Displays current SNMP security status.
Displays SNMP statistics. Each MIB object is listed along with its
status.
Displays SNMP MIB information. Information includes MIP ID number,
MIB table name, and command family.
Displays SNMP trap replay information. This includes the IP address of
the SNMP station manager that replayed each trap and the number of
the oldest replayed trap.
Displays the current SNMP trap filter status. This includes the IP
address of the SNMP station that recorded the traps and the identification
list for the traps being filtered.
Displays the current authentication failure trap forwarding status (i.e.,
enable or disable).
Displays SNMP trap information including trap ID numbers, trap
names, command families, and absorption rate. This command also displays
the Enabled/Disabled status of SNMP absorption and the Traps to
WebView service.
For more information about the resulting displays from these commands, see the OmniSwitch AOS
Release 8 CLI Reference Guide.
OmniSwitch AOS Release 8 Switch Management Guide May 2014 page 9-15