OS6860(E)_AOS_8.1.1.R01_Switch_Management_Guide

Managing Switch Configurations
Managing CMM Directory Content
Managing Switch Configurations
The following sections define commands that allow the user to manipulate the files in the directory structure.
Rebooting the Switch
When booting the switch, the software in the certified directory is loaded into the RAM memory of the
switch and used as a running configuration, as shown:
Certified
CMM
Running
The certified directory software should be the best, most reliable versions of both the image files and the
vcboot.cfg file (configuration file). The switch will run from the certified directory after a cold boot or if
the reload command is issued with no additional parameters.
To reboot the switch from the certified directory, enter the reload all command at the prompt:
-> reload all
This command loads the image and configuration files in the certified directory into the RAM memory.
Note. When the switch reboots it will boot from the certified directory. Any information in the RUNNING
CONFIGURATION that has not been saved will be lost.
page 3-8 OmniSwitch AOS Release 8 Switch Management Guide May 2014