OS6860(E)_AOS_8.1.1.R01_Switch_Management_Guide

Quick Steps for Setting Up Trap Filters
Using SNMP
Quick Steps for Setting Up Trap Filters
You can filter traps by limiting user access to trap command families. You can also filter according to
individual traps.
Filtering by Trap Families
The following example will create a new user account. This account will be granted read-only privileges to
three CLI command families (snmp, chassis, and interface). Read-only privileges will be withheld from all
other command families.
1 Set up a user account named “usermark2” by executing the user CLI command.
-> user usermark2 password ******
2 Remove all read-only privileges from the user account.
-> user usermark2 read-only none
3 Add read-only privileges for the snmp, chassis, and interface command families.
-> user usermark2 read-only snmp chassis interface
Note. Optional. To verify the user account, enter the show user command. A partial display is shown
here:
-> show user
User name = usermark2
Read right = 0x0000a200 0x00000000,
Write right = 0x00000000 0x00000000,
Read for domains = ,
Read for families = snmp chassis interface ,
Write for domains = None ,
Snmp authentication = NONE, Snmp encryption = NONE
The usermark2 account has read-only privileges for the snmp, chassis, and interface command families.
4 Set up an SNMP station with the user account “usermark2” defined above.
-> snmp station 210.1.2.1 usermark2 v3 enable
Note. Optional.To verify the SNMP Management Station, enter the show snmp station command. The
display is similar to the one shown here:
-> show snmp station
ipAddress/udpPort status protocol user
---------------------------+---------+--------+-------------------------------
210.1.2.1/162 enable v3 usermark2
The usermark2 account is established on the SNMP station at IP address 210.1.2.1.
page 9-4 OmniSwitch AOS Release 8 Switch Management Guide May 2014