Sie wollen auch ein ePaper? Erhöhen Sie die Reichweite Ihrer Titel.
YUMPU macht aus Druck-PDFs automatisch weboptimierte ePaper, die Google liebt.
4. Technical data<br />
Overall length: ca. 900 mm<br />
Overall beam: ca. 200 mm<br />
Width of buoyancy <strong>hu</strong>ll: ca. 100 mm<br />
Overall height: ca. 320 mm<br />
Weight: ca. 4100 g<br />
<br />
5. Safety Instructions<br />
1. When you are building the model please note: Be sure to use only the recommended<br />
adhesives inside the <strong>hu</strong>ll. Allow all glued joints to dry out fully before you seal the <strong>hu</strong>ll.<br />
2. The lead/acid batteries must not be charged in the sealed <strong>hu</strong>ll, as this could result in<br />
an explosion.<br />
When you want to charge the batteries, open the <strong>hu</strong>ll and remove it first. Be sure to<br />
keep to the recommended charging procedure.<br />
During the charging process inflammable hydrogen gas may be ejected through the<br />
battery´s integral safety valve. It is therefore important to wait at least 1 hour before<br />
installing the batteries in the model.<br />
3. Shortly before running the model you would naturally seal the <strong>hu</strong>ll. After sealing it, you<br />
should blow into the valve to check that the <strong>hu</strong>ll is airtight: Push a piece of silicone<br />
hose onto the valve and blow into it through your mouth. Don´t place the <strong>hu</strong>ll under<br />
excessive pressure - on no account use an air pump or compressed air.<br />
4. When you have finished running the model or when storing it away, open the <strong>hu</strong>ll.<br />
37