e-brick installation and user manual - GEW UV System v1.0
e-brick installation and user manual - GEW UV System v1.0
e-brick installation and user manual - GEW UV System v1.0
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
5.3. Setting <strong>and</strong> adjustment<br />
The e-Brick requires no setting or adjustment after <strong>installation</strong>; all functions are controlled by the<br />
<strong>GEW</strong> system HMI. A number of HMI software packages are available; refer to the relevant<br />
software <strong>manual</strong> for full details. A typical HMI setting screen is shown in Figure 8.<br />
Lamp selected<br />
Lamp power (%)<br />
Lamp type<br />
Set relationship<br />
between press speed<br />
<strong>and</strong> lamp power e.g.<br />
50% would give full<br />
power at 50% of<br />
maximum press<br />
speed<br />
Figure 8: Typical HMI settings screens<br />
Hour counter<br />
Change all<br />
lamps<br />
Using these screens the <strong>user</strong> is able to select a lamp, set the required power level, set the power<br />
ramping, <strong>and</strong> monitor lamp service hours.<br />
Warning! During commissioning, application specific parameters may be entered by the<br />
<strong>installation</strong> technician. In normal use, <strong>and</strong> to maintain the system warranty, preset parameters shall<br />
not be altered without referring to <strong>GEW</strong>.<br />
<strong>GEW</strong> <strong>UV</strong> e-Brick <strong>installation</strong> <strong>and</strong> operating <strong>manual</strong> 31 of 49