e-brick installation and user manual - GEW UV System v1.0

6.4. Routine (operator) maintenance
The e-Brick forms part of a UV drying system which requires preventative maintenance
operations in accordance with the schedule in section 10.
6.4.1. Air filter cleaning / replacement
Warning! Isolate power before changing or checking filters
The only components of the e-Brick requiring regular maintenance are the air filters. Filters
shall be checked in accordance with the system maintenance schedule in section 10; always
follow the procedures in section 9.
Advice! Record filter checks and changes for reference in the event of a warranty claim; see
section 10.1 for a suggested format.
6.5. Fault finding guidelines
Advice! All faults that may be corrected by the operator are indicated by the HMI. In the event of
a fault occurring that cannot be cleared by the operator, please refer to GEW or your local agent
for service.
Warning! There are no user serviceable parts inside the e-Brick; do not remove covers under
any circumstances. Please note that if factory security seals are broken, the warranty is void.
Should any fault occur, the alarm pop up appears on the HMI and the fault code is recorded on the
fault screen (Figure 9). Icons are defined in sections 6.5.1 and 6.5.2 below.
Figure 9: Typical ‘Alarm Warning’ and 'Fault History' screens
GEW UV e-Brick installation and operating manual 36 of 49