Hydrovar Pump Controller Installation & Operation Manual

More documents

Recommendations

Info

Technical Data 5.2 EMC Requirements (Electromagnetic Compatibility) The EMC requirements depend on the intended use. • Class B environment (EN 61800-3: Class C2) Environment that includes domestic premises, it also includes establishments directly connected without intermediate transformers to a low-voltage power supply network which supplies buildings used for domestic purposes. Examples of class B environments include houses, apartments, commercial premises or offices in a residential building. Caution: The relevant EMC regulations for which the HYDROVAR was tested in class B environments is based on the restricted use of the product and the following limitations:1) the drive voltage is less than 1000 V; 2) it is neither a plug in device nor a movable device and, 3) when used in the class B environment, it is intended to be installed and utilized by technicians with the necessary training and skills required for installing and/or using power drive systems, including specific training with respect to EMC requirements. • Class A environment (EN 61800-3: Class C3) Environment that includes all establishments other than those directly connected to a low voltage power supply network which supplies buildings used for domestic purposes e.g. Industrial areas, technical areas of any building fed from a dedicated transformer are typical examples of class A environment locations. The HYDROVAR complies with the general EMC regulations and is tested according to the following standards: EN 61800-3/2004 EN 55011 (2002) Disturbance voltages / Disturbance field strength First environment Second Environment – class B / class C2 – class A / class C3 Disturbance voltages OK OK Disturbance field strength * OK * Warning - In a domestic environment, this product may cause radio interference, in which case supplementary mitigation measures may be required. EN 61000-4-2 (2001) Electrostatic discharge EN 61000-4-3 (2002) Electromagnetic field immunity test EN 61000-4-4 (2001) Burst immunity test EN 61000-4-5 (2001) Surge immunity test EN 61000-4-6 (1996) Immunity of conducted RF-Disturbance 14
Dimensions and Weights Section 6 HVM1202, HVM1203, HVM3403, 3405 7.9 All dimensions in inches! Drawings are not to scale! Dimensions are nominal Type 2, 3 HP 1 Ph 3, 5 HP 3 Ph a … minimum center-distance between HYDROVARs 12" b … header space for maintenance 12" 15 6.7 3.35 3.35 7.4 8.9 8.2 7.9 Weight [lbs] Basic Master / Single 8.8 9.7
Page 1 and 2: ITT Goulds Pumps Hydrovar Pump Cont
Page 3 and 4: INDEX 9 Programming ...............
Page 5 and 6: System Design Section 2 The followi
Page 7 and 8: Product Overview Section 3 3.1 Hard
Page 9 and 10: Product Overview in a multi-pump-sy
Page 11 and 12: Model Number Code Section 4 (contin
Page 13: Technical Data 5.1 General Technica
Page 17 and 18: Additional Components Section 7 7.1
Page 19 and 20: Electrical Installation and Wiring
Page 35 and 36: Programming Section 9 Note Read and
Page 37 and 38: Programming When using a HYDROVAR S
Page 39 and 40: Programming 02 02 ACTUAT. FRQ. D1 X
Page 41 and 42: Programming 22 22 SELECT DEVICE * 1
Page 43 and 44: Programming 29 29 4th ERROR ERROR X
Page 45 and 46: Programming 0100 0100 SUBMENU BASIC
Page 47 and 48: Programming 0115 0115 LOCK FUNCT. O
Page 49 and 50: Programming RA: Ramp F min accelera
Page 51 and 52: Programming 0255 0255 CONF. FMIN f
Page 53 and 54: Programming 0291 0291 CURR. LIMIT 1
Page 55 and 56: Programming 0400 0400 SUBMENU SENSO
Page 57 and 58: Programming 0435 0435 SENS 1 CAL X
Page 59 and 60: Programming 0530 0530 DISABLE FRQ 3
Page 61 and 62: Programming 0570 0570 MSTPRIORITY O
Page 63 and 64: Programming 0800 0805 Config. Expla
Page 65 and 66:
Programming This pre-selected requi
Page 67 and 68:
Programming Example for using the O
Page 69 and 70:
Programming 1100 1100 SUBMENU SETUP
Page 71 and 72:
Failure Messages Section 10 Note If
Page 73 and 74:
Failure Messages Error Probable Cau
Page 75 and 76:
Failure Messages 10.3 Internal Erro
Page 77 and 78:
Programming Flow Chart Section 12 5
Page 79 and 80:
Programming Flow Chart Section 12 (
show all

Hydrovar Pump Controller Installation & Operation Manual

You also want an ePaper? Increase the reach of your titles

Delete template?

Save as template?