Repair Manual Mobile Generator - Wacker Neuson
Repair Manual Mobile Generator - Wacker Neuson
Repair Manual Mobile Generator - Wacker Neuson
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Disassembly and Assembly G 70<br />
9.8 Installing the <strong>Generator</strong><br />
Prerequisites Crane capable of lifting 227 kg (500 lb)<br />
Loctite ® 243 or equivalent<br />
Two 3/8-16 x 3-inch threaded studs<br />
Three M10x30 threaded studs<br />
Procedure Follow the procedure below to install the generator.<br />
1. Outside of the machine, secure the shock mounts (g) to the generator housing.<br />
Torque the screws to 86 Nm (63 ft.lbs.).<br />
2. Clean all paint from the mating surface (x) of the generator housing.<br />
3. Install two 3/8-16 x 3-inch studs (h) into the engine flywheel 180° away from<br />
each other.<br />
4. Install three M10x30 studs (i) into the engine bell housing at 120° intervals.<br />
5. Using an appropriate crane or hoist, lower the generator into the machine. Slide<br />
the flex discs of the generator over the 3/8-16 studs. Use the studs to guide the<br />
generator into position.<br />
This procedure continues on the next page.<br />
wc_tx001068gb.fm 90