CNC 8037 T - Operating manual - Fagor Automation
CNC 8037 T - Operating manual - Fagor Automation
CNC 8037 T - Operating manual - Fagor Automation
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
6.<br />
JOG<br />
<strong>CNC</strong> <strong>8037</strong><br />
·T· MODEL<br />
SOFT: V01.4X<br />
·104·<br />
Jog<br />
6.1 Jog<br />
6.1.1 Continuous Jog<br />
<strong>Operating</strong> <strong>manual</strong><br />
Once the % override of the jogging feedrate (indicated by axis-machine parameter "JOGFEED") has<br />
been selected with the switch at the Operator Panel , press the jog keys corresponding to the desired<br />
axis and to the desired jogging direction.<br />
The axes can be jogged one at a time and in different ways depending on the status of the general<br />
logic input "LATCHM":<br />
If the PLC sets this mark low, the axes will be jogged while pressing the corresponding<br />
Jog key.<br />
If the PLC sets this mark high, the axes will move from the moment the corresponding<br />
JOG key is pressed until the [STOP] key or other JOG key is pressed. In this case,<br />
the movement will be transferred to that indicated by the new key.<br />
If while jogging an axis, the rapid key is pressed, the axis will move at the feedrate<br />
established by machine parameter "G00FEED" for this axis as long as this key stays<br />
pressed. This feedrate will be applied while this key is pressed and it will restore the<br />
jogging feedrate percentage (0% to 120%) indicated in axis machine parameter<br />
"JOGFEED" when this key is released.
Change language