CNC 8037 T - Operating manual - Fagor Automation
CNC 8037 T - Operating manual - Fagor Automation
CNC 8037 T - Operating manual - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
3.<br />
OPERATIONS VIA ETHERNET<br />
Remote hard disk<br />
<strong>CNC</strong> <strong>8037</strong><br />
·T· MODEL<br />
SOFT: V01.4X<br />
·44·<br />
3.1 Remote hard disk<br />
<strong>Operating</strong> <strong>manual</strong><br />
The <strong>CNC</strong> can have a local hard disk (at the <strong>CNC</strong> itself) or a remote hard disk accessible through<br />
Ethernet.<br />
i<br />
The remote hard disk is configured by machine parameters. Refer to the chapter on machine<br />
parameters for Ethernet in the installation <strong>manual</strong>.<br />
As remote hard disk, it is possible to use the hard disk of a PC or just a folder. This memory space<br />
may be shared by several <strong>CNC</strong>'s or each may have its own memory space. The PC that makes its<br />
hard disk (server) public must be connected to the local network.<br />
The interface and the softkeys of the <strong>CNC</strong> will the same as if it were a local hard disk. When accessing<br />
the <strong>CNC</strong> through WinDNC or FTP, the remote hard disk behaves like a local hard disk.<br />
Protocol used<br />
The NFS protocol is used to communicate with the remote hard disk. This protocol must be available<br />
at the PC that is used as server.
Change language