CNC 8037 T - Operating manual - Fagor Automation

10.
PLC
CNC 8037
·T· MODEL
SOFT: V01.4X
·158·
Edit
"DELETE BLOCK" softkey
With this function it is possible to delete a block or group of blocks.
To delete only one block, just position the cursor over it and press [ENTER].
Operating manual
To delete a group of blocks, indicate the first and last blocks to be deleted. To do that, proceed as
follows:
1. Position the cursor over the first block to be deleted and press the "INITIAL BLOCK" softkey.
2. Position the cursor over the last block to be deleted and press the "FINAL BLOCK" softkey. If
the last block to be deleted is also the last one of the program, it can also be selected by pressing
the "TO THE END" softkey.
Once the first and last blocks are selected, the CNC will highlight the selected blocks requesting
confirmation to delete them.
"MOVE BLOCK" softkey
With this option it is possible to move a block or group of blocks by previously indicating the first and
last blocks to be moved. To do that, proceed as follows:
1. Position the cursor over the first block to be moved and press the "INITIAL BLOCK" softkey.
2. Position the cursor over the last block to be moved and press the "FINAL BLOCK" softkey. If the
last block to be moved is also the last one of the program, it can also be selected by pressing
the "TO THE END" softkey.
To move only one block, the "initial block" and the "final block" will be the same one.
Once the first and last blocks are selected, the CNC will highlight the selected blocks requesting
confirmation to move them.
Then, indicate the block after which this group of blocks must be placed. Press the "START
OPERATION" softkey to carry out this command.