CNC 8037 T - Operating manual - Fagor Automation

9.
STATUS
CNC
CNC 8037
·T· MODEL
SOFT: V01.4X
·150·
Backup
Backup is carried out using the softkey.
Operating manual
Pressing this softkey makes a safety copy (backup) of the data contained in the indicated folder.
The data is saved in the selected file.
Several backups may be done in different folders in the same unit (Hard disk, USB disk, etc.).
When doing a Backup, each file goes to its corresponding folder (PRG, TAB or PAN). If these folders
are missing, they will be created.
Backup is not possible in a subfolder PRG, TAB or PAN, only the folder containing these subfolders
may be selected.
When doing a Backup, the data is copied in the following devices:
Screens: from the hard disk (KeyCF).
Servo drive parameters: from CAN drives.
In the rest of the CNC files: from RAM memory.