CNC 8035 - Programming manual - Fagor Automation

6.12 Withdrawal of axes when interrupting a threading
operation (G233)
With function G233 it is possible to program the safety distance the axes withdraw to when
interrupting a thread (G33) either using the [STOP] key or feedhold.
This function is modal, it must be programmed alone in the block and it is displayed in the history.
This function determines the thread exit for all the threads programmed after it. If there are several
G33 functions in a row and you would like to do a different withdrawal on each one of them, program
the corresponding function G233 before each G33 function.
Function G233 may be canceled by programming it alone in a block or by programming all the
coordinates as zero. In either case, G233 disappears from history.
If the [STOP] key is pressed while executing a thread and function G233 is active, the axes withdraw
according to the distances programmed in that function. If after the withdrawal, there is an active
DSTOP, it will keep executing the blocks until an ESTOP is found.
Programming format
G233 X....C
X...C +/-5.5 Thread exit distances.
Example:
X: Incremental distance (positive or negative) to move along the thread exit axis (X axis).
Z: Incremental distance to move along the thread axis (Z axis).
X
End point
X
Z
Thread exit
point
Cycle stop
point
STOP
Starting point
Z
Programming manual
PATH CONTROL
Withdrawal of axes when interrupting a threading operation (G233) 6.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·107·