CNC 8035 - Programming manual - Fagor Automation

Programming manual
6.
PATH CONTROL
Rapid traverse (G00)
CNC 8035
·T· MODEL
(SOFT V16.3X)
·90·
6.1 Rapid traverse (G00)
The movements programmed after G00 are executed at the rapid feedrate indicated in the axis
machine parameter "G00FEED".
Independently of the number of axis which move, the resulting path is always a straight line between
the starting point and the final point.
Example programming the X axis in radius.
X100 Z100; Starting point
G00 G90 X300 Z400; Programmed path
It is possible, via the general machine parameter "RAPIDOVR", to establish if the feedrate override
% switch (when working in G00) operates from 0% to 100%, or whether it stays constant at 100%.
When G00 is programmed, the last "F" programmed is not cancelled i.e. when G01, G02 or G03
are programmed again "F" is recovered.
G00 is modal and incompatible with G01, G02, G03, G33 G34 and G75. Function G00 can be
programmed as G or G0.
On power-up, after executing M02, M30 or after EMERGENCY or RESET, the CNC assumes code
G00 or G01, depending on how general machine parameter "IMOVE" has been set.