CNC 8035 - Programming manual - Fagor Automation
CNC 8035 - Programming manual - Fagor Automation
CNC 8035 - Programming manual - Fagor Automation
You also want an ePaper? Increase the reach of your titles
YUMPU automatically turns print PDFs into web optimized ePapers that Google loves.
<strong>Programming</strong> <strong>manual</strong><br />
11.<br />
HIGH-LEVEL LANGUAGE PROGRAMMING<br />
Variables<br />
<strong>CNC</strong> <strong>8035</strong><br />
·T· MODEL<br />
(SOFT V16.3X)<br />
·234·<br />
11.2.10 Variables associated with the main spindle<br />
SREAL<br />
FTEOS<br />
SPEED<br />
DNCS<br />
PLCS<br />
PRGS<br />
CSS<br />
DNCCSS<br />
PLCCSS<br />
PRGCSS<br />
In these variables associated with the spindle, their values are given in revolutions per minute and<br />
the main spindle override values are given in integers from 0 to 255.<br />
Certain variables interrupt block preparation (it is indicated in each one) and the <strong>CNC</strong> waits for that<br />
command to be executed before resuming block preparation.<br />
Read-only variables<br />
Returns the real main spindle turning speed in revolutions per minute. It interrupts block preparation.<br />
(P100=SREAL)<br />
It assigns to P100 the real turning speed of the main spindle.<br />
It returns the theoretical turning speed of the main spindle.<br />
Returns, in revolutions per minute, the main spindle speed selected at the <strong>CNC</strong>.<br />
This turning speed may be indicated by program, by PLC or by DNC; the <strong>CNC</strong> selects one of them,<br />
the one indicated by DNC has the highest priority and the one indicated by program has the lowest<br />
priority.<br />
Returns the turning speed in revolutions per minute, selected by DNC. If it has a value of 0 it means<br />
that it is not selected.<br />
Returns the turning speed in revolutions per minute selected by PLC. If it has a value of 0 it means<br />
that it is not selected.<br />
Returns the turning speed in revolutions per minute, selected by program.<br />
It returns the constant surface speed selected at the <strong>CNC</strong>. Its value is given in the active units (ft/<br />
min or m/min).<br />
This constant surface speed may be indicated by program, by PLC or by DNC; the <strong>CNC</strong> selects one<br />
of them, the one indicated by DNC has the highest priority and the one indicated by program has<br />
the lowest priority.<br />
It returns the constant surface speed selected via DNC. Its value is given in m/min or ft/min and it<br />
is 0 it means that it is not currently selected.<br />
It returns the constant surface speed selected by PLC. Its value is given in m/min or ft/min.<br />
It returns the constant surface speed selected by program. Its value is given in m/min or ft/min.
Change language