CNC 8035 - Programming manual - Fagor Automation

12.8 Screen customizing instructions
Customizing instructions may be used only when customizing programs made by the user.
These customizing programs must be stored in the CNC'S RAM memory and they may utilize the
"Programming Instructions" and they will be executed in the special channel designed for this use;
the program selected in each case will be indicated in the following general machine parameters.
In "USERDPLY" the program to be executed in the Execution Mode will be indicated.
In "USEREDIT" the program to be executed in the Editing Mode will be indicated.
In "USERMAN" the program to be executed in the Manual (JOG) Mode will be indicated.
In "USERDIAG" the program to be executed in the Diagnosis Mode will be indicated.
The customizing programs may have up to five nesting levels besides their current one. Also, the
customizing instructions do not allow local parameters, nevertheless all global parameters may be
used to define them.
( PAGE (expression) )
The mnemonic PAGE displays the page number indicated by means of a number or by means of
any expression resulting in a number.
User-defined pages will be from page 0 to page 255 and will be defined from the CNC keyboard
in the Graphic Editor mode and as indicated in the Operating Manual.
System pages will be defined by a number greater than 1000. See the corresponding appendix.
( SYMBOL (expression 1), (expression 2), (expression 3) )
The mnemonic SYMBOL displays the symbol whose number is indicated by means of the value of
expression 1 once this has been evaluated.
Its position on screen is also defined by expression 2 (column) and by expression 3 (row).
Expression 1, expression 2 and expression 3 may contain a number or any expression resulting in
a number.
The CNC allows displaying any user-defined symbol (0-255) defined at the CNC keyboard in the
Graphic Editor mode such as is indicated in the Operating Manual.
In order to position it within the display area its pixels must be defined, 0-639 for columns (expression
2) and 0-335 for rows (expression 3).
Programming manual
PROGRAM CONTROL INSTRUCTIONS
Screen customizing instructions 12.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·267·