CNC 8035 - Programming manual - Fagor Automation

Programming manual
11.
HIGH-LEVEL LANGUAGE PROGRAMMING
Variables
CNC 8035
·T· MODEL
(SOFT V16.3X)
·228·
PRGFPR
PRGFIN
FRO
DNCFRO
PLCFRO
CNCFRO
PLCCFR
PRGFRO
It returns the feedrate, in mm/turn or inches/turn selected by PLC. If it has a value of 0 it means that
it is not selected.
It returns the feedrate, in mm/turn or inches/turn selected by program.
Read-only variables associated with function G32
It returns the feedrate selected by program, in 1/min.
Likewise, the CNC variable FEED, associated with G94, indicates the resulting feedrate in mm/min
or inches/min.
Read-only variables associated with the override
It returns the feedrate override (%) currently selected at the CNC. It is given in integer values between
0 and "MAXFOVR" (maximum 255).
This feedrate percentage may be indicated by program, by PLC, by DNC or by the front panel; the
CNC selects one of them and the priority (from the highest to the lowest) is: by program, by DNC,
by PLC and from the front panel switch.
It returns the feedrate override % currently selected by the DNC. If it has a value of 0 it means that
it is not selected.
It returns the feedrate override % currently selected by the PLC. If it has a value of 0 it means that
it is not selected.
It returns the feedrate override % currently selected by the switch.
It returns the feedrate percentage currently selected by the PLC's execution channel.
Read-write variables associated with the override
This variable may be used to read or modify the feedrate override percentage currently selected
by program. It is given in integer values between 0 and "MAXFOVR" (maximum 255). If it has a value
of 0 it means that it is not selected.
(P110=PRGFRO)
It assigns to P110 the % of feedrate override selected by program.
(PRGFRO=P111)
It sets the feedrate override % selected by program to the value of P111.