CNC 8035 - Programming manual - Fagor Automation

9.7.1 Basic operation
The canned cycle will analyze the programmed profile performing, if necessary, a horizontal turning
operation until the defined profile is reached.
The whole turning operation is carried out with the same pass which is the same or smaller than
the programmed one "C". Each turning pass is carried out as follows:
"1-2” move in rapid (G00).
Move “2-3” in G01 at programmed feedrate (F).
If "D" has been programmed, the 3-4 move is done in rapid (G00); but if "D" has not been
programmed, the 3-4 move is done following the profile in G01 at the programmed feedrate (F).
The withdrawal movement "4-5" is made in rapid traverse (G00).
If a final roughing pass has been programmed, the CNC will run a pass parallel to the profile
maintaining an "L" and "M" stock at the set feedrate "F". This final roughing pass will eliminate the
ridges that were left in the roughing stage.
After the turning operation (with or without finishing pass) the canned cycle will always end at the
cycle calling point.
Programming manual
CANNED CYCLES
G84. Turning canned cycle for curved sections 9.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·189·