CNC 8035 - Programming manual - Fagor Automation

DECLARATION OF CONFORMITY
The manufacturer:
Fagor Automation S. Coop.
Barrio de San Andrés Nº 19, C.P. 20500, Mondragón -Guipúzcoa- (SPAIN).
Declares:
Under their responsibility that the product:
8035 CNC
Consisting of the following modules and accessories:
8035-M, 8035-T
Note. Some additional characters may follow the references mentioned above. They all comply with the directives
listed. However, check that that's the case by checking the label of the unit itself.
Referred to by this declaration with following directives:
Low voltage regulations.
EN 60204-1: 2006 Electrical equipment on machines — Part 1. General requirements.
Regulation on electromagnetic compatibility.
EN 61131-2: 2007 PLC — Part 2. Unit requirements and tests.
As instructed by the European Community Directives 2006/95/EEC on Low Voltage and 2004/108/
EC on Electromagnetic Compatibility and its updates.
In Mondragón, July 27th, 2010.
CNC 8035
·11·