CNC 8035 - Programming manual - Fagor Automation

9.12 G89. Z axis grooving canned cycle
This cycle performs a grooving operation along the Z axis maintaining the same pass between the
successive passes being this equal to or smaller than the one programamed.
The basic structure of the block is as follows:
G89 X Z Q R C D K
X±5.5
Defines the X coordinate of the initial point of the groove. It must be programmed in absolute
coordinates and in the active units, radius or diameter.
Z±5.5
Defines the Z coordinate of the initial point of the groove. It must be programmed in absolute
coordinates.
Q±5.5
Defines the X coordinate of the final point of the groove. It must be programmed in absolute
coordinates and in the active units, radius or diameter.
R±5.5
Defines the Z coordinate of the final point of the groove.
C5.5
Defines the grooving pass. It is programmed in radius.
If not programmed, the CNC will assume the width of the cuttter (NOSEW) of the active tool and
if programmed with a zero value, the CNC will issue the corresponding error message.
D5.5
Defines the safety distance.
If not programmed, a value of 0 is assumed.
K5
Defines the dwell, in hundredths of a second, after each penetration until the withdrawal begins.
If not programmed, a value of 0 is assumed.
Programming manual
CANNED CYCLES
G89. Z axis grooving canned cycle 9.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·209·