CNC 8035 - Programming manual - Fagor Automation

3.8.2 Using the work zones
Within each work zone, the CNC allows you to restrict the movement of the tool, either prohibiting
its exit from the programmed zone (no exit zone) or its entry into the programmed zone (no entry
zone).
The CNC will take the dimensions of the tool into account at all times (tool offset table) to avoid it
exceeding the programmed limits.
The presetting of work zones is done via Function G22, the programming format being:
G22 K S
Where:
S= 1 No entry zone S = 2 No exit zone
K Indicates the work zone you wish to define (1, 2, 3 or 4).
S Indicates the enabling/disabling of the work zone.
S=0 disabled.
S=1 enabled as a no-entry zone.
S=2 enabled as a no-exit zone.
On power-up, the CNC will disable all work zones. However, upper and lower limits for these zones
will not undergo any variation, and they can be re-enabled through the G22 function.
Programming manual
AXES AND COORDINATE SYSTEMS
Work zones 3.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·57·