CNC 8035 - Programming manual - Fagor Automation

A1
It defines the main machining axis.
When programming "A0", the Z axis will be the main axis, "I" will be taken as X residual value
and "C" as the pass along X.
When programming "A1", the X axis will be the main axis, "I" will be taken as Z residual value
and "C" as the pass along Z.
When not programming the A parameter, the "I" and "C" values depend on the tool dimensions..
If the X length of the tool is greater than its Z length, the "I" value is assumed as excess material
in X and the "C" value as a pass in X.
If the X length of the tool is smaller than its Z length, the "I" value is assumed as excess material
in Z and the "C" value as a pass in Z.
L±5.5
It defines the finishing stock in X. It is defined in radius and if not programmed, it assumes a value
of "0".
M±5.5
It defines the finishing stock in Z.
If "L" or "M" is programmed with a negative value, the finishing pass is carried out in round corner
mode (G05). When both parameters are programmed with a positive value, the finishing pass is
carried out in square corner mode (G07).
If the parameter "M" is not programmed, the residual stock in X and Z will be the one indicated in
parameter "L" and the roughing passes will be identical keeping the "C" distance between 2
consecutive passes.
H5.5
It defines the feedrate during the finishing pass.
If not programmed or programmed with a 0 value, it does not run the finishing pass.
S4
Defines the label number of the block where the geometrical description of the profile of the part
starts.
Programming manual
CANNED CYCLES
G66. Pattern repeat cycle canned cycle 9.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·155·