CNC 8035 - Programming manual - Fagor Automation

4.4.1 Coordinate preset and S value limitation (G92)
Via Function G92 one can select any value in the axes of the CNC, in addition to limiting the spindle
speed.
Coordinate preset.
When carrying out a zero offset via Function G92, the CNC assumes the coordinates of the axes
programmed after G92 as new axis values.
No other function can be programmed in the block where G92 is defined, the programming format
being :
G92 X...C ±5.5
The values assigned to the axes are programmed in either radius or diameter depending on the
setting of axis machine parameter "DFORMAT".
; Positioning in P0
G90 X0 Z200
; Preset P0 as part zero
G92 X0 Y0
; Programming according to part coordinates
G91 X30 Z-30
Z-30
X20
X20 Z-40
Z-30
Spindle speed limitation
Programming "G92 S5.4", the CNC limits the spindle speed to the value set by S5.4.
This means that the CNC will not accept, from that block on, the programming of S values higher
than the maximum defined. Neither is it possible to exceed this maximum value from the
keyboard on the front panel.
Programming manual
REFERENCE SYSTEMS
Coordinate preset and zero offsets 4.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·63·