CNC 8035 - Programming manual - Fagor Automation

9.3.1 Basic operation
The machining passes
Once the necessary roughing passes have been calculated, it will machine the new resulting profile.
The machining operation will be performed keeping the square corner mode (G07) or round corner
mode (G05) that is active when calling the cycle. Likewise, it maintains the same pass during the
whole machining operation.
The profile and the tool
After analyzing the programmed profile and depending on the tool used, it will execute that profile
or the one closest to it if the one programmed cannot be executed. When the programmed profile
(valleys) cannot be executed with the selected tool, a message will be displayed at the beginning
of the execution of the cycle.
The operator will have the choice to stop the execution and select the right tool. If he doesn't do that,
the CNC calculates a new profile in the areas that cannot be accessed by the selected tool and it
machines as much as possible. The message is shown during the whole machining operation.
Machining of channels
If when running one of the roughing passes, the CNC detects that there is a channel, the CNC will
go on executing the rest of the profile ignoring that channel. A profile may have an unlimited number
of channels.
Programming manual
CANNED CYCLES
G69. Z axis roughing canned cycle 9.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·171·