CNC 8035 - Programming manual - Fagor Automation

Programming manual
11.
HIGH-LEVEL LANGUAGE PROGRAMMING
Variables
CNC 8035
·T· MODEL
(SOFT V16.3X)
·224·
11.2.4 Variables associated with machine parameters
MPGn
MP(X-C)n
MPSn
MPLCn
These variables associated with machine parameters are read-only variables. These variables may
be read and written when executed inside an OEM program or subroutine.
Refer to the installation and start-up manual to know the format of the values returned. The values
of 1/0 correspond to the parameters that are set as YES/NO, +/- or ON/OFF.
The coordinate and feedrate values are given in the active units:
If G70, in inches (within ±3937.00787).
If G71, in millimeters (within ±99999.9999).
If rotary axis in degrees (within ±99999.9999).
Modify the machine parameters from an OEM program or subroutine.
These variables may be read and written when executed inside an OEM program or subroutine. In
this case, these variables can be used to modify the value of certain machine parameters. Refer
to the installation manual for the list of machine parameters that may be modified.
In order to be able to modify these parameters via PLC, an OEM subroutine containing the relevant
variables must be executed using the CNCEX command.
Read-only variables
Returns the value assigned to general machine parameter (n).
(P110=MPG8)
It assigns the value of the general machine parameter P8 "INCHES" to parameter P110,
if millimeters P110=0 and if inches P110=1.
Returns the value assigned to the machine parameter (n) of the indicated axis (X-C).
(P110=MPY 1)
Assigns the value of Y axis machine parameter P1 "DFORMAT" to parameter P110.
Returns the value assigned to the indicated machine parameter (n) of the main spindle.
Returns the value assigned to the indicated machine parameter (n) of the PLC.