CNC 8035 - Programming manual - Fagor Automation

7.5 Mirror image (G10, G11. G12, G13, G14)
The functions to activate the mirror image are the following.
G10: Cancel mirror image.
G11: Mirror image on X axis
G12: Mirror image on Y axis.
G13: Mirror image on Z axis
G14: Mirror image on any axis (X..C), or in several at the same time.
Examples:
G14 W
G14 X Z A B
When the CNC works with mirror images, it executes the movements programmed in the axes that
have mirror image selected, with the sign changed.
The following subroutine defines the machining of part “A”.
G90 G00 X40 Z150
G02 X80 Z110 R60
G01 Z60
X120 Z0
The programming of all parts would be :
Execution of subroutine ; machines “A”.
G13 ; Mirror image on Z axis.
Execution of subroutine ; machines “B”
M30 ; End of program
Functions G11, G12, G13, and G14 are modal and incompatible with G10.
G11, G12, and G13 can be programmed in the same block, because they are not incompatible with
each other. Function G14 must be programmed alone in the block.
If while one of the mirror imaging functions (G11, G12, G13, and G14) is active, a new coordinate
origin (part zero) is preset with G92, this new origin will not be affected by the mirror imaging function.
On power-up, after executing M02, M30 or after EMERGENCY or RESET, the CNC assumes code
G10.
Programming manual
ADDITIONAL PREPARATORY FUNCTIONS
Mirror image (G10, G11. G12, G13, G14) 7.
CNC 8035
·T· MODEL
(SOFT V16.3X)
·125·