FS-1030D Service Manual - kyocera

2G6
Connector Pin No. Signal I/O Voltage Description
YC10
Connected
to the
waste toner
sensor
1 +5V O 5 V DC 5 V DC power supply for waste toner sensor
2 TNFULL I 0/5 V DC Waste toner sensor: Toner Full/Normal
3 SGND - Ground Ground
YC11
Connected
to the bias
PWB
YC12
Connected
to the bias
PWB
YC13
Connected
to the
switchback
solenoid
YC14
Connected
to the paper
sensor
1 SGND - Ground Ground
2 SGND - Ground Ground
3 SGND - Ground Ground
4 +5V O 5 V DC 5 V DC power supply
5 +5V O 5 V DC 5 V DC power supply
6 +5V O 5 V DC 5 V DC power supply
7 HVCLK O 0/5 V DC (pulse) Developing bias output clock signal
8 ZCROSS I 0/5 V DC (pulse) Zero cross signal
9 MHVDR2 O 0/5 V DC Main charger output control 2: On/Off
10 EXITN I 0/5 V DC Exit sensor: On/Off
11 PSEL1 O 0/5 V DC Transfer bias output control signal: On/Off
12 SLEEP O 0/5 V DC Sleep mode control signal: On/Off
13 +5V O 5 V DC 5 V DC power supply
14 HVISEL O 0/5 V DC Transfer bias (current) control signal: On/Off
15 HEATN O 0/24 V DC Heater lamp: On/Off
16 RTHVDR O 0/5 V DC Transfer bias (reverse) control signal: On/Off
1 THERM I Analog Fuser thermistor temperature detection signal
2 THVDR O 0/5 V DC Transfer bias: On/Off
3 FAN1 O 0/12/24 V DC Cooling fan rotation: High/Low/Stop
4 FAN2 O 0/24/24 V DC Cooling fan rotation: Half/High/Stop
5 MHVDR1 O 0/5 V DC Main charger output control signal 1: On/Off
6 +24V2 O 24 V DC 24 V DC power supply
7 TONER I 0/5 V DC Toner sensor detection signal: Normal/Empty
8 RESIT I 0/5 V DC Registration sensor: On/Off
9 SWIN I 0/5 V DC Cassette switch: On/Off
10 PGND - Ground Ground
11 PGND - Ground Ground
12 +24V3 O 24 V DC 24 V DC power supply
13 +24V3 O 24 V DC 24 V DC power supply
1 DUDR1 O 0/24 V DC Switchback solenoid: On/Off
2 COMMON O 24 V DC 24 V DC power supply
3 DUDR2 O 0/24 V DC Switchback solenoid: On/Off
1 +5V O 5 V DC 5 V DC power supply for paper sensor
2 PAPER I 0/5 V DC Paper sensor: On/Off
3 GND - Ground Ground
2-3-7