FS-1030D Service Manual - kyocera

2G6
Service items
Description
No. Item Description
Total page
Toner install mode
Parallel I/O information
Serial I/O error code
USB information
Operator panel lock status
(displayed only when locked)
NVRAM error
(displayed only when any error has occurred)
Printable area setting
Left offset for each paper source
Top offset for each paper source
Offset for page rotation
Serial interface information
(displayed only when serial interface
board IB-11 installed)
Operator panel message language
Number of rebooting for vertical distortion
check
Fixed asset number
Media type attributes
Media type attributes
Memory SPD information (slot 1)
Engine parameter setting
Machine serial number
Total print page count
-
-
00: Normal
Bit 0: Framing error
Bit 1: Overrun error
Bit 2: Parity error
00: Not connected
01: Full-Speed
02: Hi-Speed
01: Partial lock
02: Full lock
01: ID error
02: Version error
03: Checksum error
04: NVRAM crash error
/Top offset/Left offset/Page length/Page width
/MP tray/Cassette/Option paper feeder/(non support)
/MP tray/Option paper feeder/(non support)
/Top offset/Left offset/
RS2: RS-232C
RS4: RS-422A
PMSG command setting (decimal)
-
(maximum 16 characters)
Media type setting value from 1 to 28 (fuser temperature,
paper thickness, duplex printing)
(unused media type always 0x00.)
Media type setting value from 1 to 28 (print density)
(unused media type always 0x00.)
32 bytes (2 to 6 bytes, 8 to 36 bytes and 94 to 95 bytes)
Hexadecimal, 128 bytes (256 digits)
-
1-4-4