Intel Server Board S1200BT - PROconsult Data A/S

Jumper Blocks
Intel® Server Board S1200BT TPS
8. Jumper Blocks
The server board has several 3-pin jumper blocks that can be used to configure, protect or
recover specific features of the server board.
Figure 46. Jumper Blocks (J4A2, J1F1, J1F3, J1F2, and J1E2) on S1200BTL
Table 42. Server Board Jumpers (J1F1, J1F2, J1F3, J1E2, and J4A2) on S1200BTL
Jumper Name Pins System Results
J1E2: CMOS
Clear
J1F2: ME Force
Update
J1F1:
Password Clear
J1F3: BIOS
Recovery
J4A2: BMC
Force Update
1-2 These pins should have a jumper in place for normal system operation. (Default)
2-3 If these pins are jumpered with AC power plugged, the CMOS settings are cleared within
five seconds. These pins should not be jumpered for normal operation.
1-2 ME Firmware Force Update Mode – Disabled (Default)
2-3 ME Firmware Force Update Mode – Enabled
1-2 These pins should have a jumper in place for normal system operation. (Default)
2-3 If these pins are jumpered, administrator and user passwords are cleared within 5-10
seconds after the system is powered on. These pins should not be jumpered for normal
operation.
1-2 These pins should have a jumper in place for normal system operation. (Default)
2-3 Given that the main system BIOS will not boot with these pins jumpered, system can only
boot from EFI-bootable recovery media with the recovery BIOS image.
1-2 Integrated BMC Firmware Force Update Mode – Disabled (Default)
2-3 Integrated BMC Firmware Force Update Mode – Enabled
104
Intel order number G13326-003
Revision 1.0