MicroStrategy 7 Administrator Guide

51
Security Filters
CHAPTER 51
Apply a security filter to a user
6WHSV
Select the project in which you wish to apply a security filter.
From the Administration menu, choose Configure Project. The Project
Configuration Editor opens.
On the Security Filter tab, choose the user to which you wish to apply a
security filter.
Click Import. The Select a Filter dialog box appears.
In the Select a Filter dialog box, locate the filter definition you wish to use
and click Open. You are returned to the Project Configuration Editor.
If you wish, click Add to specify a top range attribute or a bottom range
attribute.
Click OK.
H
O
W
D
O
I
1RWHV
• If you do not specify a top range attribute, then the security filter applies to
every level higher than the bottom range attribute.
• If you do not specify a bottom range attribute, then the security filter applies to
every level lower than the top range attribute.
• If neither a top range attribute nor a bottom range attribute is specified, the
security filter is applied to every level of analysis.
193