New Products

General Accessory
DEHNpanel
• Visual remote indicator for surge protective
devices (SPDs)
• Easy installation
• For installation into switchgear cabinet doors
• Low energy consumption due to current-saving
LEDs
• Supplied by two AA batteries
• Easy battery replacement without opening the
switchgear cabinet door
• Wire breakage detection by connecting the
break contact of the remote signalling contact
Visual indicator for surge protective devices for installation in switchgear
cabinets
DEHNpanel provides remote indication of the status of surge protective
devices with remote signalling contact installed in a switchgear installation.
The status of the surge protective device is clearly indicated by means of
high-luminosity LEDs even under difficult lighting conditions. DEHNpanel
can be easily integrated into existing switchgear installations, allowing
the operator of the installation to easily test the surge protective devices
installed without opening the switchgear cabinet.
The current-saving LEDs ensure a long battery service life of several
years.
Batteries can be replaced by ordinary persons since the switchgear cabinet
does not have to be opened.
+
10
96
green
56
65
48
remote signalling
contact
signal
evaluation
red
Dimension drawing DPAN L
Basic circuit diagram DPAN L
910 200
DPAN L
DPAN L
910 200
Überspannungsschutz-Statusanzeige
LED grün/rot für Einbau
DEHNpanel mit
Type
DPAN L
Part No. 910 200
Voltage supply
2x 1.5 V AA batteries
Operating state/fault indication
green LED (flashing) / red LED (flashing)
Flashing frequency
0.1 s on / 1.3 s off
Enclosure material (front / rear side)
noryl
Degree of protection IP 40 / IP 20
Operating temperature range T U
-25°C...+60°C
Mounting dimensions
92 x 45 mm
Dimensions
96 x 48 x 75 mm
Accessories
www.dehn.de
147