e - Spotlight Promotions
e - Spotlight Promotions
e - Spotlight Promotions
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
• make it<br />
EASTER GARLANDS/<br />
BUNTING<br />
Materials<br />
Coordinating plain/printed card/papers<br />
1cm wide ribbon or trim<br />
Adhesive alphabet letters<br />
Single hole punch<br />
Pencil<br />
Scissors<br />
1. Using the template provided cut<br />
out 24 bunny head shapes from<br />
coordinating card/papers. Use single<br />
hole punch to punch a hole in each<br />
bunny ear 1cm down from the top<br />
edge.<br />
2. Cut end of ribbon on an angle and<br />
thread ribbon through the holes of 11<br />
bunny heads for the top bunting. Space<br />
bunny heads as desired leaving extra<br />
ribbon before the first and after the<br />
last bunny head. To make a hanging<br />
loop at each end of ribbon, loop over<br />
10cm and tie a firm knot.<br />
3. Repeat with remaining 13 bunny<br />
heads on another length of ribbon to<br />
make lower garland. Again allow extra<br />
ribbon at each end enough so that it<br />
will hang lower than the top garland.<br />
4. Hang garlands and adjust bunny<br />
heads to the centre and balance the<br />
garlands.<br />
Stick on adhesive letters as desired.<br />
EASTER EGG HATS<br />
Use for chocolate eggs or as a gift card<br />
for eggs.<br />
Materials<br />
Coordinating plain/printed card/papers<br />
Coordinating ribbons<br />
Adhesive alphabet letters<br />
Crafters Choice Craft glue<br />
Pencil & ruler<br />
Scissors<br />
Gift egg<br />
1. Using the template provided cut<br />
out one bunny head shape per gift egg<br />
from coordinated card/papers. Cut a<br />
3cm wide strip from printed papers.<br />
Glue one end of the paper strip to the<br />
centre back of paper bunny head, allow<br />
to dry.<br />
2. Wrap the strip around the gift egg<br />
and allowing enough overlap at the<br />
centre back of the paper bunny head<br />
trim excess paper strip. Remove egg<br />
and glue the overlapping end of the<br />
strip to the back of the bunny head.<br />
Allow to dry.<br />
3. Embellish the front of the bunny<br />
head by gluing on ribbon bows.<br />
DECOFOAM EGG CHICK<br />
& BUNNY<br />
Materials<br />
Crafters Choice PVA glue<br />
Sharp pencil<br />
Scissors<br />
Wire cutting pliers<br />
Bunny<br />
75mm decofoam egg<br />
3 x white chenille sticks<br />
3 x hot pink chenille sticks<br />
1 x small white pompom<br />
1 x medium white pompom<br />
1 x pair of joggle eyes<br />
Coordinating ribbon<br />
Chick<br />
75mm decofoam egg<br />
2 x yellow chenille sticks<br />
1 x orange chenille stick<br />
1 x pair of joggle eyes<br />
Coordinating ribbon<br />
Bunny<br />
1. To make bunny’s feet, bend a white<br />
chenille stick in half. Make two loops<br />
by bringing each end back to the bend<br />
in the middle. Twist the ends around<br />
98 spotlight.com.au www.facebook.com/gcqmag