INtime® 3.1 Software - tenAsys

Chapter 8: Preparing an RT node
4. Format the hard/flash disk by entering:
format c: /u
5. Run the RT setup program by entering:
rtsetup c: 1
where c: is the drive and 1 is the partition number.
6. Copy the contents of Installation Floppy 1 and Installation Floppy 2 (created
earlier) to the hard/flash disk:
A. Insert Installation Floppy 1, prepared by the batch file, into the floppy drive
and then enter this command to copy the floppy disk’s contents to the hard/
flash disk:
copy *.* c:
B. Insert Installation Floppy 2, prepared by the batch file, into the floppy drive
and then enter this command to copy the floppy disk’s contents to the hard/
flash disk:
copy *.* c:
C. Remove the floppy disk and reboot the system.
The system reboots and loads the INtime software’s remote RT kernel and
system applications. The RT node can now communicate with the
Windows host.
Special requirements for Flash disks
• Ensure that DOS can detect the flash disk as the C: drive.
• Ensure that you can format and fdisk the flash disk from DOS.
• Ensure that these basic ROM BIOS functions are available:
• INT 13H (disk I/O)
• INT 15H (Extended memory access)
• INT 10H (video)
79