ZM-71SE About version 1.2.1.0 - Soliton

[P3] Tab Window (corresponds to 2-23)
This paragraph is explained about additional each menu in this book page 9-[5] Others.
Blink
”OFF Time” (*100msec) / “ON Time” (*100msec)
When the value is “0” , the conventional blink time (about 0.5 seconds interval) comes.
* In case of ZM70, you can not set.
Touch Switch (Analog Switch / Matrix Switch)
When using the ZM80 matrix type, select [Matrix Switch].
The types for matrix switch are as follows;
Model ZM82 ZM72 ZM43
No. of switches(WH) 5030 4024 2012
(Order product)
Transfer comments (ZM80 only)
When checking this setting, the comments in each editing item can be transferred with the
screen data to a ZM80.
* The capacity of the comments will be added to the total memory capacity of the screen
data.
Memory Capacity +2M
The default setting is [checked]. If the used ZM80 (except for ZM42) has the memory
capacity less than 2M, uncheck the setting.
When unchecking the setting, decrease the total memory capacity in [Memory Use] of [Tool].
Use Internal Flash ROM as Back-up Area
See page 14 in detail.
Use ladder monitor
- See the ZM-42/52/72/82 User’s Manual Ladder Monitor version in detail.
- When you use ladder monitor function, check the mark in this item. If check mark was
done, ZM series transfer ladder monitor program (expansion program)with screen data
at the same time.