ZM-71SE About version 1.2.1.0 - Soliton

Address $s76 (correspondense to page 15-11)
If a keypad for Entry mode is placed on an overlap, it is possible to turn OFF the overlap
when pressing the [ENT] key of a keypad.
If you want to prohibit the above function, use this system memory address.
When the value except for [0] is set, the Auto-OFF function of an overlap is prohibited. For
more information, refer to the "Chapter 9 Entry Mode" page 9-15.
Address $s77 (ZM80 Function)
When inputting the value except for [0], the exclusive function of overlap is valid.
For more information, refer to the "Chapter 4 Overlap" page 4-12.
Address $s100, 101 (corresponds to page 15-11)
These are the memories related to calendar.
$s100: Write the calendar condition at the PLC (with a built-in calendar) side.
[0] : normal
[1] : error (cannot read the calendar information.)
$s101: Writing the data to calendar on a PLC (e.g. : [SET_CLND] on macro commands) will
be accessible regardless of the condition of PLC calendar, by setting the value except
for [0] in this memory. The error is not processed even if the error is detected.
(Before this version, it is impossible to write the data when the condition of calendar
on PLC has some error.)
Address $s104, 105 (ZM80 Function)
Specify the error processing of ZM80 reading/writing the data to a PLC by macro commands
when communicating with a PLC.
For example, when the writing target memory address is specified as the indirect PLC
memory in the MOV command, the communication error will happen as soon as the value of
the indirect PLC memory exceeds the range of the PLC side.
This command can prevent the above communication error.
$s104: When the value is [0], the error is processed when the error occurs in reading/writing
the data. The processing way is defined by the setting of [Comm. Error Handling]
(Stop/Continuous) at the [Comm. Parameter]. When reading data, the next macro
command executes after receiving for the result. The write command of macro is
unilateraly sent, and the next command is executed without waiting for the result of
the write command. When setting the value except for [0], only the result is stored
into the memory $s105.
When sending the read/write command of macro, the next command is not executed
until receiving the result whether the action is finished or not after the order for writing
is given. So, it takes more time to process than [0] (normal).
$s105: The result of error is output by [0] (normal) or except for [0] (error).
Address $s106, 107 (ZM80 Function)
When using Memo Pad Function, store the information about Memo Pad Function.
$s106: Store the page number of the present displayed memo pad.(Page No. : 0~7)
$s107: Store the information whether the data is registered or not in each page of memo pad
(the maximum 8 pages). 15 14 13 12 11 10 9 8 7 6 5 4 3 2 1 0
0 : Data unregistered
1 : Data registered
Page 0
Page 1
Page 2
Page 3
Page 4
Page 5
Page 6
Page 7