ZM-71SE About version 1.2.1.0 - Soliton

(corresponds to page 29-10)
Error
ZM80 ZM70 No. Contents
Remedies
69
A pattern size larger than the
screen has been specified.
Reset the pattern.
70
Excessive data sheet columns/lines
Check the data sheet columns/lines,
and reset if necessary.
71
The parts for a closed area graph
exceed 64KB (ZM-42D/L: 32KB).
Reduce the size of the parts.
Bit sampling mode with [
Real
Specify the setting of [Real Time
Additional
item
72
Time Print] are over 4, or there are
more than two bit sampling modes
which has the same [Buffer No] with
[ Real Time Print].
Print] according to the limits of
setting. After checking the version,
please contact the technical support
of your distributor.
81
Macro: FOR-NEXT command
number is wrong.
Correct the FOR-NEXT command.
Macro: There are two different
Delete or correct the label command
82
commands for the same label
number.
being used for two different
commands.
83
Macro: There is no destination label
for the jump.
Change or create the destination
label.
84
Macro: Invalid memory
Change macro.
90
You attempted to use a screen
library that is not registered.
The bitmap area cannot be con-
Check the screen library number.
structed.
100
ZM-30 compatibility is not available
for the input mode when the
universal serial is selected.
Change settings for the entry mode.
120
[Multi-Link] is not selected at
[Modular Jack 1/2] in case of [Multi-
Link2].
Select [Multi-Link] at [Modular Jack
1 (or 2)].
Additional
item
121
Station number error in [Multi-
Link2]. The value of the [Local Port]
or the [Total] is out of the range of 1
Set the value of the [Local Port] or
the [Total] within the range of 1 to 4.
to 4.