ZM-71SE About version 1.2.1.0 - Soliton

Chapter 11 : Graphic Display
[1] Graphic Relay Mode (corresponds to page 11-14)
Display Area Part
Additional item
Outline of display area part
When using a display area part in Graphic Relay mode, it is possible to change the
graphic display position easily.
The [Offset] location in the graphic library fits in the upper left corner of the display
area part on a screen.
Graphic Library
Display Area
Screen No. 0 Screen No. 6
Even if a display area part is not placed for Graphic Relay mode, it can be
executed normally. In this case, the display location of the graphics are the same
as in the graphic library.
Click the [Display Area] icon of the graphic relay mode tool bar. The list of the display
area parts is displayed. Select a part and place it.
Mode Display Area Dialog
[Division No.]
The display area part to be linked with graphic relay mode must be set with the same division
number as the original [Graphic Relay] dialog. It thus becomes associated with the parts
used in graphic relay mode.
[Area Prop.] (Foreground color/background color/tile)
It is possible to change inside properties in display area parts.
[Display area transparent]
When checking this item, the property of the display area part becomes transparent. It is
useful to avoid the condition that the background on the base is hidden by the display area
part.
[ Display area transparent]
[ Display area transparent]
in the [Display Area] dialog
This setting is available for the display area parts which do not have the drawing
properties only (for example, No. 0 of both [Parts_e.zm80p] and [Std.zm80p]).