Model SR715 Model SR720 LCR Meters

REMOTE PROGRAMMING8 Instrumentation Amp Error. The input instrumentation amplifier failedits test.9 Output Error. The output impedance selector failed its test. Thiserror may occur if there is a part in the fixture when the test isexecuted.$CBT(?) i {,j}The $CBT command sets amplitude calbyte i to the value j. i may range from0 to 94, and j from 0 to 255.$CFT(?) i {,x} The $CFT command sets floating point calbyte i to the floating point value x.$CMJ(?) {x}$CMN(?) {x}$CNT?$CRN(?) {i}$CTS? i$DIA(?) {i}$FRQ(?) {x}$GAN(?) {i}$INP(?) {i}$INT(?) {i}$PHS(?) {i}The $CMJ command sets the major parameter to be used in the standardresistor calibration to x Ohms. If x differs by more than 10% from the nominalvalue of the range being calibrated an error is generated.The $CMN command sets the minor parameter value for standard resistorcalibration. x has units of ppm and may range between ±9999.9 ppm with 0.1ppm resolution. The $CMN? query reads the current minor parameter.Reads the raw A/D converter counts when in diagnostic mode.The $CRN command sets the range to be calibrated in standard resistorcalibration to range i. The $CRN? query reads the present calibration range.The $CTS? query returns the raw A/D converter counts during normalmeasurements. i = 0 and i = 1 return the inphase and quadrature counts forthe voltage measurement, while i = 2 and i = 3 return the inphase andquadrature counts for the current measurement.The $DIA command disables (i=0) and enables (i=1) diagnostic modemeasurements. The $DIA? query returns the diagnostic mode status.The $FRQ command sets the frequency correction factor to x ppm. x isrounded to the nearest 0.1 ppm and must be less than ±10000 ppm. The$FRQ? query returns the current frequency correction factor.The $GAN command sets the instrumentation amplifier gain to setting i whenthe instrument is in diagnostic mode. The $GAN? query returns the presentgain setting.The $INP command sets the input multiplexer to input i when the instrumentis in diagnostic mode. The $INP? query returns the present input setting.The $INT command sets the measurement time to i cycles of the drivewaveform. i may range between 1 and 10000 cycles, restricted so that thetotal measurement time is less than 10 seconds. The $INT? query returns thepresent measurement time.The $PHS command sets the phase of the measurement relative to the drivesignal when the instrument is in diagnostic mode. The phase can be 0° (i=0),180° (i=1), 90° (i=2), or 270° (i=3). The $PHS? query returns the presentmeasurement phase.$RND(?) {i} The $RND command sets the rounding of the measurement results. If i = -1the SR715/720 automatically rounds to the correct number of digits given thecurrent range, value, etc.. If i = 0, 1, 2, or 3 the measurement result will berounded to 5 - i digits of resolution. The $RND? query returns the currentrounding setting.4-9