Stratos®Pro A4... PH User Manual

ORP Calibration
Display Action Remark
Select ORP calibration,
proceed with enter
Remove the sensor
and temperature
probe, clean them, and
immerse them in the
redox buffer.
Enter setpoint value for
redox buffer.
Press enter to proceed.
The ORP delta value is
displayed (based on
25°C).
Sensoface is active.
Press enter to proceed.
To repeat calibration:
Select REPEAT.
To exit calibration:
Select MEAS, then press
enter
Display (3 sec)
Now the device is in
HOLD mode.
After end of calibration,
the outputs remain
in HOLD mode
for a short time.
135