FlowCERT (UL)
UL manual - Pulsar Process Measurement
UL manual - Pulsar Process Measurement
- No tags were found...
Create successful ePaper yourself
Turn your PDF publications into a flip-book with our unique Google optimized e-Paper software.
Auxiliary<br />
P810 Units<br />
This parameter determines whether the Measurement units (P104) are<br />
displayed on the auxiliary line of the display in run mode.<br />
Option<br />
Description<br />
0 = No Measurement units will not be displayed<br />
1 = Yes (Default) Measurement units will be displayed<br />
P811 Alarms Messages<br />
This parameter determines whether notification messages are displayed on<br />
the auxiliary line of the display in run mode when an alarm relay is switched<br />
on or off. The message is in the form “Alarm High ON”, where the ‘High’ is<br />
determined by the setting of the relay Alarm ID (P212, 222, 232, 242, 252).<br />
Option<br />
Description<br />
0 = No (Default) Alarm messages will not be displayed<br />
1 = Yes Alarm messages will be displayed<br />
P812 General Control or Pump Messages<br />
This parameter determines whether notification messages are displayed on<br />
the auxiliary line of the display in run mode when a pump or general control<br />
relay is switched on or off. The message is in the form “General 1 ON”,<br />
where the number displayed is the number of the relay.<br />
Option<br />
Description<br />
0 = No (Default) Pump messages will not be displayed<br />
1 = Yes Pump messages will be displayed<br />
P813 Control Messages<br />
This parameter determines whether notification messages are displayed on<br />
the auxiliary line of the display in run mode when a control relay is switched<br />
on or off. The message is in the form “Time ON”.<br />
Option<br />
Description<br />
0 = No (Default) Control messages will not be displayed<br />
1 = Yes Control messages will be displayed<br />
Page 102