YME Engineering Course

J. SEQUENCE CONTROL FUNCTION
text for the referenced signals cannot be edited on the sequence table
editing window.
J.2.2 SEQUENCE DESCRIPTION EXAMPLE
The basic logical circuit figure for the AND and OR commands is described in the
sequence table as shown in the following figure.
Figure AND Circuit Example
In the example in this figure, for AND operator, only when two condition signals
are satisfied, the operation may be performed.
Figure OR Circuit Example
In the example in this figure, for OR operator, any one of the two conditions is
established, the operation may be performed.
J.2.3 SEQUENCE TABLE PROCESSING FLOW
The figure below shows the sequence table processing flow.
YME Training Center J-5
CS3KR3-ENG 1 ST Edition Jan 2002