YME Engineering Course

T. PROJECT COMMON DEFINITION
♦ Auto mode
Direct entry into the engineering unit symbol field in the Function Block
Detail Builder will automatically define the engineering unit symbol. The
Engineering Unit Symbol Builder can also be used to define the symbol.
♦ Manual mode
The engineering unit symbol can only be defined in the Engineering Unit
Symbol Builder.
Use the System View to switch between the auto and manual modes. Use the
Detailed Setting tab of the project properties to switch between the modes.
Check the corresponding check box to select the manual mode.
T.7. SWITCH POSITION LABEL BUILDER
Up to 64 sets numbered Nos.1 to 64 of switch position labels can be defined for
one project. One set consists of four labels (label 1, label 2, label 3, and label 4).
Figure: Switch position label builder
YME Training Center
T-12
CS3KR3-ENG 1 ST Edition Jan 2002