YME Engineering Course

E. PROJECT CREATION
D. ENGINEERING ENVIRONMENT
The engineering work is done on the ENG (Engineering Station), which has the
standard builder function or system generation function installed. There are
potentially following two types of engineering environment.
♦ Target System
♦ Non-Target system
D.1. TARGET SYSTEM
In case of target system, the system generation is done on the ENG and loaded
to the components connected on-line. In this case all the system hardware is
connected in the network.
Ethernet
HIS
ENG
V-Net
FCS
Figure: Target system.
D.2. NON-TARGET SYSTEM
In case of non-target system, the system generation is done on a non-target
ENG without any of the CS3000 system components. Once all the generation is
completed, the same is tested using the virtual test function. The project is then
copied into a secondary media and loaded on to the target ENG and then off-line
downloaded to all the components after the complete network is connected. This
function allows the engineering work to start even before the actual CS3000
hardware components are procured.
YME Training Center
D-1
CS3KR3-ENG 1 ST Edition Jan 2002