YME Engineering Course

Q. HIS WINDOW CONFIGURATION
• Call Data Input Dialog
• Call Menu Dialog
• Data-Item Dependent Menu Dialog
• Execute the Multimedia Function
• Report Printout
• Call Panel set
• Others
♦ Window Size
This sets whether or not to specify a window size. When specifying a
window size, select a window size from [Large Size], [Medium Size], or
[Special Size]. This item may be disabled depending on the type of the
window selected. If a window display size is not specified, with the some
exceptions, the window displays in the same size of the window where it is
called up. The display size saved by the window set function is valid only
when the window display size specification is omitted.
♦ Window Display Position (Specify Coordinate)
This sets the display position of a window to be called. Check the [Specify
Coordinate] check box. The following two types of methods are used to
set the display position.
• Using the spin box
This sets the display position, using X- and Y-coordinates. The
setting range is between -5000 and 3686400.
• Using the mouse
Press the [Specify window display position] button to enable setting
by the mouse. The cursor shape changes as shown below during
the setting, and the button changes to [Exit Specification].
Figure: Cursor Displayed when Specifying a Window Display Position
The display position reference point is located at the top left corner
of the drawing area. The “setting window display position” is
optional. If it is not selected, the window display position cannot be
specified.
♦ Window Display Position (Monitor Number)
Windows display position can be specified with a monitor number instead
of the coordinates. If the HIS is installed with multiple monitoring
packages, this setting is required. Check [Specify Monitor No.] check box,
and then spin the spin box for setting the monitor number. 1 or 2 can be
selected.
YME Training Center
Q-12
CS3KR3-ENG 1 ST Edition Jan 2002