LCS III - Konica Minolta Sensing Americas, Inc.

Standard Operations
5.7.1.1 Set up single wavelength mode
Options Description
More For further Options
Store Off/On
56
Press Single Wavelength in the Main Menu. Press Options for
Parameter Setup. Table 7 describes the single wavelength setup
options.
Table 7 Single wavelength setup options
With the Store On setting, all measurement data are stored automatically. With the Store Off
setting, no measurement data are stored.
% Trans/Abs To switch to % transmittance, concentration or absorbance readings
λ Wavelength
To enter the measurement wavelength. Use the alphanumeric keypad to enter the measurement
wavelength. The entered wavelength must be in the range from
320–1100 nm.
Send Data To send data to a printer, PC or USB memory stick
Concentration Factor Multiplication factor for converting absorbance values into concentration values.
Concentration
Resolution
Reading Mode
Recall Data
To select the position of the decimal point in the calculated concentration readings.
Single Reading Mode: A reading is only displayed after a measurement has been carried out
(press Read; standard setting) (see section 5.7.1.2 on page 58).
Continuous Reading Mode: After the zero measurement, all readings are displayed
automatically and continuously (see section 5.7.1.3 on page 58).
Call up saved measurement data, wavelength scans or time courses, see section 5.3 on
page 28.
Instrument Setup Basic data of the instrument, see section 5.2 on page 17.