Processor Local Bus Functional Model Toolkit User's Manual

8.8.9 PLB_rdBurst
The following error messages are issued for this signal:
• Error 2.31.1
PLB_rdBurst and PLB_RESET are active at the same time.
• Error 2.31.2
PLB asserted PLB_rdBurst without a primary or secondary read burst transfer acknowledged.
• Error 2.31.3
PLB_rdBurst does not match M-rdBurst during a read burst transfer.
• Error 2.31.4
PLB reasserted PLB_rdBurst before the current burst transfer received its last dAck.
• Error 2.31.5
PLB failed to deassert PLB_rdBurst after bTerm was received for the current burst transfer.
8.8.10 PLB_wrBurst
The following error messages are issued for this signal:
• Error 2.32.1
An error message is issued if this transfer qualifier does not match Mn_wrBurst during a primary
request with PLB_PAValid active.
• Error 2.32.3
An error message is issued when PLB_wrBurst is re-asserted before the last Sln_wrDAck of a
burst transfer is received.
• Error 2.32.4
An error message is issued when PLB_wrBurst is active the cycle after Sln_wrBTerm.
• Error 2.32.5
An error message is issued when PLB_wrBurst is active and SYS_plbReset is active.
• Error 2.32.6
An error message is issued when PLB_wrBurst is active during a non-burst write cycle.
• Error 2.32.7
An error message is issued when the PLB changes this transfer qualifier from when a primary
request to transfer is made until the addressed slave asserts its Sln_addrAck, or the transfer is
terminated via Mn_abort or PLB_MnRearbitrate or Timeout.
8.8.11 PLB_rdPrim
The following error messages are issued for this signal:
• Error 2.33.1
90 Processor Local Bus Functional Model Toolkit Version 4.9.2