COMAND - Mercedes Benz USA

As soon as the vehicle location is found again,
route guidance continues in the usual
manner.
Navigation Announcements
G Warning
Navigation announcements are intended to
direct you while driving without diverting your
attention from the road and driving.
Please always use this feature instead of
consulting the map display for directions.
Consulting the symbols or map display for
directions may cause you to divert your
attention from driving and increase your risk
of an accident.
i During an active telephone call, the
navigation announcements are
suppressed.
If you have missed an announcement, you can
call up the current announcement at any
time.
X To request current announcement: In
map view with the menu system
(Y page 54) displayed, selectRPT.
X To switch off navigation
announcements: During the
announcement, press the B button.
You will briefly see the message: The
driving instructions have been
muted.
X To switch navigation announcements
back on manually: In map view with the
menu system (Y page 54) displayed, select
RPT.
or
X Start a new route calculation (Y page 70).
or
X If COMAND is switched on again or the
engine is restarted.
X To set the volume of the
announcements: Set the volume during
the automatic announcement (Y page 35).
or
X Call up an announcement manually by
selecting RPT in map view with the menu
system displayed.
X Adjust the volume.
Audio Fadeout
The Audio Fadeout function, if activated,
lowers the volume of the current audio source
when a navigation announcement is issued.
As soon as the navigation announcement has
ended, the audio source will be played with
the previous volume (Y page 60).
Canceling Route Guidance
X In the map display with the menu system
displayed (Y page 54) select Destination
£Cancel Route Guidance.
Resuming Route Guidance
X Select Destination£Continue Route
Guidance in map view with the menu
system displayed.
COMAND calculates the route.
Detour Function
Route Guidance 85
i The Detour function blocks a route
segment ahead. You can set the length of
the block. COMAND calculates a detour
route if possible.
X Select Route£Detour in map view with
the menu system displayed.
X To set the length of block: Select
Longer or Shorter repeatedly until the
required length is set.
The blocked segment is highlighted in red/
white on the map. Shown at the top of the
display is the length of the blocked
Z
Navigation