Config Panel (2.40) - Guntermann und Drunck GmbH

Device monitoring via SNMP
lowing data in the paragraph of the same name:
Access: Activate the View access (View) or deny the access (No) via
SNMPv2c protocol.
Source: Enter the IP address or the address space of the addresses of
incoming SNMP packets.
Read-only
community:
6. If you want to process the packets of the SNMPv3 protocol version, enter the following
data in the paragraph of the same name:
7. Click OK to save your settings and to leave the window.
36 · G&D DL-MUX
Examples:
192.168.150.187: Only IP address 192.168.150.187
192.168.150.0/24: IP addresses of space 192.168.150.x
192.168.0.0/16: IP addresses of space 192.168.x.x
192.0.0.0/8: IP addresses of space 192.x.x.x
Enter the name of the Community which has also been
selected in the Network Management System.
IMPORTANT: The transfer of the packet password (Community) of the SNMPv2c
protocol version is not encrypted. It can therefore be easily tapped!
If required, use the SNMPv3 protocol version (see below) and a high Securitiy
level to ensure a secure data transfer.
Access: Activate the View access (View) or deny the access (No) via
SNMPv3 protocol.
User: Enter the username for the communication with the Network
Management System.
Authentication
protocol
Authentication
passphrase
Select the authentication protocol (MD5 or SHA) which has
been activated in the Network Management System.
Enter the authentication passphrase for the communication
with the Network Management System.
Security level Select between one of the following options:
NoAuthNoPriv: user authentication and Privacy protocol
deactivated
AuthNoPriv: user authentication activated, Privacy protocol
deactivated
AuthPriv: user authentication and Privacy protocol activated
Privacy protocol: Select the Privacy protocol (DES or AES) which has been
activated in the Network Management System.
Privacy passphrase:
Enter the privacy passphrase for secure communication with
the Network Management System.